FMC 250/280

48V/80V

The FCM280 is very similar to the FMC220 with respect to its hardware, however, it distinguishes itself with significantly higher currents and a slightly higher voltage. Both systems are identical from a system interface and programming point of view.

In contrast to FCM220, this controller is supplied in a 19 inch rack. A linear fault compensation is optionally available.

The FCM250/280 are especially suited for our larger XY-tables such as KT470 and higher, as well as tables from the PLT-series if maximum speeds are not required.

Description FMC 250 FMC 280
Trajectories no no
Gantry yes yes
Max. Number of Axes 9 (128) 9 (128)
Stepper Motor SM yes yes
Brush Motor DC yes yes
Servomotor AC / BLDC liwithed speed liwithed speed
Linear Motor ironless EDLM liwithed speed yes
Linear Motor iron DLM no liwithed speed
Piezomotor PM no no
Nanomotion Piezo NM no no
Max. Motor Voltage 24V … 48V 24V … 80V
Max. Motor Continuous Current 8A 10A
Absolute Scale yes yes
Analogue Scale yes yes
Dual loop Encoder yes yes
Max. Encoder Input Digital 40Mhz 40Mhz
Max. Encoder Input Analog 450kHz 450kHz
Compensation optional, linear, with adapted Firmware optional, linear, with adapted Firmware
RS232 / USB yes yes
Ethernet yes yes
Bus CAN, CANopen, EtherCAT CAN, CANopen, EtherCAT
I/O (z.B. for Brake) (2 in, 2 out) per axes, Joystick (2 in, 2 out) per axes, Joystick
STM Quick Access yes yes
Emergency Off yes yes
Safe Torque Off optional yes
Safe Speed Control no optional
Housing 19“ Rack 3HE 19“ Rack 3HE

Are you looking for a technical solution for your application?

Get your first 3D Design in a few days:

 

Katja Weißbach
Consulting
 

T +49 (0) 351 88585-64
E-mail

Francisco Samuel
Consulting &
Project Management

T +49 (0) 351 88585-85
E-Mail

Our references